Radwin 5000 - To Upgrade from a Non-JET Based HBS to a JET Based HBS; Upgrading an Installed Sector

RADWIN5000ConfigurationGuide Release4.9.17 8‐6
ToUpgradefromanon‐JETbasedHBStoaJETbasedHBS Backup,Restore,andUpgrade
8.6ToUpgradefromanon‐JETbasedHBStoa
JETbasedHBS
6. CarryoutaSyst emBackupasexplainedabove(seeSystemBackuponpage 8‐1)
7. Switchthehardwarefromthenon‐JETbasedHBStoaJETbasedHBS.
8. InstalltherelevantsoftwareontheJETbasedHBS.
9. CarryoutaConfigurationRestoreontheJETbasedHBSasexplainedabove(see
ConfigurationRestoreonpage 8‐2).
8.7UpgradinganInstalledSector
 Toupgradesoftwareforalink:
1. IntheRADWINManager,clicktheSoftwareUpgradebutton.TheSoftwareUpgrade
Utilityopens:
Figure8‐2:SoftwareUpgradeUtility‐Mainwindow
ThedefaultsitesshownintheSoftwareUpgradelistpanelbelongtothecurrently
installedsector.ThelistmaybeemptyifyouarerunningtheRADWINManager
“offline”.
2. TheSoftwareupgradelisttitlebarhasthreebuttonsontherighthandside.
Figure8‐3:Add/Removesitebuttons