Radwin 5000 User Manual

RADWIN5000ConfigurationGuide Release4.9.17 6‐5
AirInterface DirectHSUConfiguration
Figure6‐5:HSUConfig.‐AirInterfaceforstand‐alonefixedHSU
ForanomadicHSUtheAirInterfacedisplayisdifferent.First,theSectorIDisreplacedbythe
NetworkID.ForaregisteredHSU,neithertheNetworkIDorCBWcanbetouched:
Figure6‐6:HSUConfig.‐AirInterface,registerednomadicHSU
ForanunregisteredorunsynchronizedHSU,youmayeditbothofthesefields:
Figure6‐7:HSUConfig.‐AirInterface,stand‐alonenomadicHSUorHMU
UsethisfeaturetoswitchanomadicHSUtoadifferentnetwork.
WherehasmyHSUgone?
SupposethatyouinstalledtwocollocatedHBSswithcontiguous sectors.Itispossiblethatan
HSUlocatedclosetothecommonsectorboundarymay“discover”thewrongHBS.AHSUcan
be“forced”acrosstoanotherHBSbychangingitsSectorIDtothatoftherequiredHBS.To

Radwin 5000 Specifications

General

Channel Bandwidth	5 MHz, 10 MHz, 20 MHz, 40 MHz
Encryption	AES
Product Type	Point-to-Point
Interface	Ethernet
Frequency Bands	5.1 GHz, 5.4 GHz, 5.8 GHz
Modulation	Adaptive Modulation (QPSK to 256QAM)