Radwin 5000

RADWIN5000ConfigurationGuide Release4.9.17 10‐4
SettingupanHSUforQoS QualityofService
3. EnsurethattheModefieldisEnabled.IfyoualreadyconfiguredtheHBS(sector)for
DiffservorVLAN,thenitwillbeenabledbydefault(see10.5forVoIP).
4. IfyouhaddisabledaqueueinStep4above,agreencheckmarkwillnotbeshown
nexttoitsname,andyouwillnotbeabletoconfigurethatqueue.
5. SettheWeightpercentageforeachqueue.Thisdetermineswhatpercentageofthe
throughputwillbededicatedfortheindicatedqueue.
Ifyouexceed100%totalweight,youwillreceiveanerrormessage.
Youmustcorrectthisbeforeleavingthewindowotherthanbycancellation.
Ifyouareunder‐booked,forexamplebysettingaqueuetozero,theunusedweight
willbedistributedtotheremainingqueues.Theeffectofdoingthiswillonlybecome
apparentundercongestion.Inparticular,aqueuesettozeroweightwillbecome