65
SCC
Edition 10-2008a
1) Switch on unit
2) Set DIP 1 on operator PCB to „“ON““ position
3) Press service key
4) On the displays the following available Service - modules will be shown
5) Activate selected service module by push on display or push on central dial
6) Deactivate selected service module by pushing on “return“ symbol
Returning to SCC display / cooking mode only possible from Diagnostic mode!
7) Set DIP 1 on operator PCB to “OFF“ position to deactivate Service level
Starting with software version 01-07-02 gas related information is not shown on electric units!
Function data entry through central dial: press dial icon rst, frame will turn to red ==> only
no the value can be changed.
Service level SCC
1
2
3
4
on
1
2
3
4
on
Diagnostic
Running Times
Basic Settings
Function Test
RESET
1 - DIAGNOSTIC
Cabinet B1
130°C 345°C
act max
To Next Page
Loading...
Need help?
General
