RED RAVEN OPERATION GUIDE
COPYRIGHT © 2016 RED.COM, INC 955-0127_V6.3, REV-E | 105
RESTORE SYSTEM
Reset Defaults offers two (2) types of restores: Reset Defaults and Wipe Camera.
RESET DEFAULTS
Reset Defaults changes all settings to the factory default values. To perform a Reset Defaults, follow the
instructions below:
1. Go to Menu > Settings > Maintenance > Restore System.
2. Select Reset Defaults.
3. Select YES on the screen that asks you to confirm the action.
The camera turns off.
4. Turn on the camera.
WIPE CAMERA
Wipe Camera deletes all user settings, including: calibration files, overlays, presets, and looks. Wipe Camera
restores all factory defaults.
1. Go to Menu > Settings > Maintenance > Restore System.
2. Select Wipe Camera.
3. Select YES on the screen that asks you to confirm the action.
The camera turns off.
4. Turn on the camera.
REDISCOVER (HARDWARE REDISCOVER)
Rediscovers all hardware and caches the data for future boot cycles. Perform a Hardware Rediscover if a
module is not functioning correctly.
To perform a Hardware Rediscover, follow the instructions below:
1. Go to Menu > Settings > Maintenance.
2. Select Rediscover.
3. Select Yes on the screen that asks you to confirm the Hardware Rediscover.
The camera turns off.
4. Turn on the camera.
SYSTEM STATUS
The System Status menu displays key project and system information on the following tabs: Project Status,
Attached Modules Camera Info.
PROJECT STATUS
Displays the current camera and project settings. Includes the following tabs: File Format, Recording, Quicktime,
Look, Other.
ATTACHED MODULES
Lists the attached RED modules, and expanders. This screen does not list attached displays, media modules,
and lenses.
CAMERA INFO
Displays the following camera information:
Type: Camera type and sensor type.
To Next Page
Loading...
Need help?
General
