EasyManuals Logo

RED Raven User Manual

RED Raven
201 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
RED RAVEN OPERATION GUIDE
COPYRIGHT © 2016 RED.COM, INC 955-0127_V6.3, REV-E | 33
ENABLE AUTO BOOT ON POWER
1. Toggle the Auto Boot on Power switch to On (identified by a white star).
2. Connect a power source to the DC IN connector.
The camera turns on automatically.
3. Use one of the following methods to turn off the camera:
Go to Menu > Power and select Shutdown.
Press and hold PWR/REC until the Shutting Down... notification shows on the display.
NOTE: Simply disconnecting the power source may result in data loss.
DISABLE AUTO BOOT ON POWER
1. Toggle the Auto Boot on Power switch to Off (identified by a black star).
The camera will not turn on automatically.
CONFIGURE YOUR CAMERA
This section describes common options for configuring your camera system.
INSTALL THE DSMC2 SIDEKICK
This section applies to the following items:
DSMC2 Sidekick (Forged CF)
DSMC2 Sidekick (Woven CF)
DSMC2 Sidekick (Magnesium)
NOTE: Each DSMC2 Sidekick is compatible with RED RAVEN™.
WARNING: Before installing or removing the DSMC2 Sidekick, you MUST turn off the camera.
REQUIRED TOOL: T10 TORX
®
driver
1. Turn off the camera.
2. Use a T10 TORX driver to remove the four (4) screws on the BRAIN
®
side plate (if the side plate is installed).
3. Remove the BRAIN side plate (if the side plate is installed).
4. Place the DSMC2 Sidekick in the slot where the lip of the BRAIN side plate was installed.
5. Press the DSMC2 Sidekick down flush along the side of camera.
6. Tighten the four (4) captive screws in a cross pattern (“X” pattern) using a T10 TORX driver. DO NOT FULLY
TIGHTEN.
7. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T10 TORX driver.
WARNING: DO NOT OVERTIGHTEN.
REMOVE THE DSMC2 SIDEKICK
This section applies to the following items:
DSMC2 Sidekick (Forged CF)
DSMC2 Sidekick (Woven CF)
DSMC2 Sidekick (Magnesium)
NOTE: Each DSMC2 Sidekick is compatible with RED RAVEN.
WARNING: Before installing or removing the DSMC2 Sidekick, you MUST turn off the camera.
REQUIRED TOOL: T10 TORX driver
1. Turn off the camera.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RED Raven and is the answer not in the manual?

RED Raven Specifications

General IconGeneral
Sensor TypeRED Dragon
Dynamic Range16.5+ stops
Media TypeRED MINI-MAG
Weight3.5 lbs (body only)
Resolution4608 x 2160
Frame Ratesup to 120 fps at 4.5K
Lens MountCanon EF
Recording FormatREDCODE RAW
ISO RangeISO 800 native

Related product manuals