To Next Page

To Previous Page

RED RAVEN OPERATION GUIDE

SET UP STEREO/3D CONFIGURATION

NOTE: Master/Slave operation requires a GIG-E port, which is available on the DSMC2 REDVOLT Expander and

DSMC2 Jetpack-SDI Expander. For more information, go to “GIG-E (Ethernet)” on page 181.

This section describes basic procedures for connecting two (2) cameras in a Master/Slave configuration for 3D

operation.

NOTE: When providing the signals to a Stereo Image Processor (SiP) for verifying 3D alignment, set the HD-SDI

monitor output on both cameras to have the same overlay configuration.

NOTE: For genlock to function correctly, the cameras must be on the same firmware version, and must be using

the same project time base and recording frame rate.

To set up a Stereo/3D setup, follow the instructions below.

1. On both cameras, set the project time base and recording frame rate.

2. On both cameras, follow the instructions in “Sensor Sync” on page 136 to achieve Sensor Sync genlock

status.

The GEN and SYNC indicators in the Lower Status Row illuminate green.

3. Follow the instructions in “Set Up Master/Slave Operation” on page 138 to set Master and Slave camera

settings.

4. On both cameras, follow the instructions in “Set Reel Number, Camera ID, and Camera Position” on page

140 to set up media and camera settings.

REQUIRED CABLES

Use one (1) per camera:

 DSMC2 REDVOLT Expander or DSMC2 Jetpack-SDI Expander: 75 ohm BNC cable (such as the RED HD-SDI

Cable, P/N 790-0341)

Use one (1) per setup:

 790-0163: Master/Slave Gig-E Cable (4')

Questions and Answers:

Need help?

Do you have a question about the RED Raven and is the answer not in the manual?

RED Raven Specifications

General