RED RAVEN OPERATION GUIDE
COPYRIGHT © 2016 RED.COM, INC 955-0127_V6.3, REV-E | 37
VIDEO MONITOR OUTPUTS
NOTE: HD-SDI and HDMI
®
ports are only available on select DSMC2 expanders. For more information, go to
“Input/Output Connectors” on page 167.
The monitoring path converts RAW sensor data to a white balanced 12-bit depth 1920 x 1080 pixel RGB 4:4:4
video signal. The signal may be modified using ISO, White Balance, or other RGB color space adjustments. The
signal is then scaled and gamma-corrected to provide monitor outputs at 10-bit depth in 4:2:2 YCC or 8-bit
depth in 4:4:4 RGB.
The camera offers the following monitor outputs:
EVF/LCD: Supports a RED EVF or LCD display.
HD-SDI: Provides a 720p or 1080p output suitable for monitoring or recording to an external VTR or DDR
device. It may be configured for 10-bit LIN (VIDEO) or 10-bit LOG (FILM) encoded data.
HDMI: Provides a 480p, 720p, or 1080p output suitable for monitoring via a Windows
®
monitor or most
HDTVs.
VIDEO MONITOR CATEGORIES
NOTE: HD-SDI and HDMI ports are only available on select DSMC2 expanders. For more information, go to
“Input/Output Connectors” on page 167.
Video monitor outputs are separated into three (3) categories:
VIEWFINDER: The Upper Status Row, Live Action Area, and Lower Status Row display. Default output is the
EVF/LCD connector located on top of the camera. If an EVF or LCD is not connected, you can transfer the
VIEWFINDER output to either the HDMI or 3G-SDI (HD-SDI) output from an expander.
PROGRAM/Clean: None of the graphic overlays display.
PREVIEW: The Live Action Area and associated graphic overlays display.
For more information about changing the video monitor category of your monitor, go to “Monitor Control” on
page 60.
RECORD
Perform one of the following actions to begin recording:
Press PWR/REC on the camera.
Press REC on the media bay.
Press START/STOP on the DSMC2 Top Handle or DSMC2 Outrigger Handle.
Double-tap the right 25% on an attached touchscreen display (when enabled).
NOTE: To enable Double-Tap Right 25% to Record, go to Menu > Settings > Display > Monitor Control > Advanced
> Gestures.
RECORD VIA HD-SDI OR HDMI
NOTE: HD-SDI and HDMI ports are only available on select DSMC2 expanders. For more information, go to
“Input/Output Connectors” on page 167.
NOTE: The secondary LCD/EVF port (on the side of the camera) and the HDMI port cannot be used at the same
time. For more information, go to “LCD/EVF 2 / HDMI Select” on page 65.
This section describes how to record via HD-SDI or HDMI through simultaneous record (recording to an SSD
and an external recorder at the same time) or external record only.
To Next Page
Loading...
Need help?
General
