The interior Section R
2 Remove windscreen, weatherstrip, and side
door
seals.
3 Remove rear
view
mirror, interior lamp and
sun visors.
4
Peel
down
top section
of
'A'
post trim
covers.
5
Spring the
two
headlining listing rods from
the retainers.
6 Withdraw
listing rods from headlining and
mark
to
ensure correct replacement.
To
replace
1 Thread the listing rods in the correct order,
into the
new
headlining.
2 Starting from the front
apply contact
adhesive
to
the edge
of
the headlining.
3 Ensuring the headlining is central
to
the
vehicle roof, temporarily tack the cloth·to the
windscreen aperture using spire
clips.
4
Apply
adhesive to the rear edge
of
the
headlining and
fit
over roof moulding. The
headlining
should
be
kept
as
taut
as
possible.
5
Apply
adhesive
to
R.H. edge
of
headlining,
fit
listing rods into retainers and tack cloth
to
door aperture, again using spire clips.
6 Repeat operation for L.H. side ensuring the
headlining is kept taut.
7 Trim excess material from headlining.
8
Allow
the adhesive to take and then remove
spire
clips.
9 Using a light coating
of
adhesive
fit
top
of
R.H.
and L.H.
'A'
post trim covers over
headlining.
1
0 Replace door seals and windscreen.
11
Refit sun visors, interior lamp and rear
view
mirror.
12
Reconnect battery.
Fascia and centre console
To
remove
(see
Figure
5)
1 Disconnect battery.
2 Remove windscreen (see
Section
Q).
3
Press
in retaining lugs, remove heater and
choke Knobs from centre console.
4 Remove gear lever knob.
5 Remove
two
No. 8 screws securing rear
of
centre console to driveshaft tunnel. Then lift
centre console, complete
with
gaiter, over gear
lever.
6 Remove steering wheel (see
Section
D).
7 Remove multiswitch (see
Section
T).
8 Remove clamping bracket securing steering
column to fascia.
9 Disconnect instruments and switches (see
Section
T).
10
Remove radio,
if
fitted (see
Section
V).
11
Remove
two
No. 8 screws securing centre
of
fascia to engine bulkhead.
12
Remove single No. 8 countersunk screw
securing centre
of
fascia
top
to body.
6
13
Remove single
bolt
securing
R.H.
and L.H.
side
of
fascia
to
body.
14
The fascia can
now
be
removed from the
vehicle.
To
replace
1 Locate the fascia and secure to the body at
the five fixing points.
2 Reconnect instruments and switches.
3 Refit radio,
if
fitted.
4
Secure steering column clamping bracket
to
base
of
fascia.
5 Refit multiswitch and cover.
6 Refit steering
wheel.
7 Refit centre console.
8 Refit gear
lever knob.
9 Refit heater and choke
control knobs.
10
Refit windscreen.
11
Reconnect battery.
To Next Page
Loading...
