REXROTH ECODRIVE03 - Page 118

6-2 Index ECODRIVE03-SGP-03VRS
DOK-ECODR3-SGP-03VRS**-WA01-EN-P
Configurated length > max. length for AT 5-5
Configurated length > max. length for MDT 5-4
construction of a diagnostic message 1-1
Continuous current limit active 4-33
Continuous current limit pre-warning 4-35
Control and power sections ready for operation 5-31
Controller type S-0-0140 wrong 5-15
Cooling fan too slow 4-28
Current measurement trim wrong 4-15
D
Default parameter load 5-20
Default parameters invalid 5-20
Default parameters not available 5-19
Diagnostic Message Display
(2 dots) 5-41
Diagnostic Message Display
-0 5-41
-1 5-41
-2 5-41
-3 5-41
-4 5-41
-5 5-41
-6 5-41
E1 5-42
E2 5-42
E3 5-42
E4 5-42
E5 5-42
diagnostic message output priority 1-3
diagnostic message types 1-1
display 1-2
Distance home switch - reference mark erroneous 5-18
Double MDT failure shutdown 4-16
Double MST failure shutdown 4-16
Drive active, switching not allowed 5-17
Drive controlled homing procedure command 5-18
Drive controlled interpolation, encoder 1 5-32
Drive controlled interpolation, encoder 2 5-32
Drive controlled interpolation, lagless, encoder 1 5-33
Drive controlled interpolation, lagless, encoder 2 5-33
Drive controlled positioning, encoder 1 5-37
Drive controlled positioning, encoder 1, lagless 5-37
Drive controlled positioning, encoder 2 5-37
Drive controlled positioning, encoder 2, lagless 5-38
Drive deceleration to standstill 5-40
Drive does not move 5-22
Drive enable refused 5-22
Drive HALT 5-30
Drive in control at start of command 5-22
Drive in TORQUE control 5-31
Drive in VELOCITY control 5-31
Drive not ready for commutation command 5-21
Drive overtemp. prewarning 4-31
E
Emergency-Stop 4-18, 4-20, 4-40
Encoder 1 failure
quadrant error 4-7
signal amplitude wrong 4-22
Encoder 2 failure
quadrant error 4-10, 4-24
signal amplitude wrong 4-9, 4-24
Encoder combination not possible 5-15
Erroneous internal hardware synchronization 4-14
error
reset the error 4-1
error diagnostic messages 4-1