REXROTH ECODRIVE03 - Page 120

6-4 Index ECODRIVE03-SGP-03VRS
DOK-ECODR3-SGP-03VRS**-WA01-EN-P
Low battery voltage 4-11
M
Mains fault 4-16, 4-36, 4-42
Master drive encoder failure
quadrant error 4-13
signal too small 4-12
Max signal frequency of encoder 2 exceeded 4-11
Max. signal frequency of encoder 1 exceeded 4-7
Maximum braking time exceeded 4-6
Measuring wheel operation not possible 5-26
Modulo range error 5-14
Motion range exceeded during commutation 4-22, 5-23
Motor feedback data not valid 5-27
Motor overload 4-28
Motor overtemp. prewarning 4-31
Motor overtemperature shutdown 4-4
Motor temp. surveillance defective 4-5
Motor type P-0-4014 incorrect 5-9
N
Negative limit switch activated 4-41
Negative position limit exceeded 4-40
Negative travel limit exceeded 4-19
Negative travel limit switch detected 4-21
No adjustment with asynchronous motor 5-22
No ready signal from supply module 4-16, 4-37, 4-42
Not homed 4-32
O
Only allowed without master 5-17
Operation status 5-43
Order of MDT configuration wrong 5-7
Overcurrent
short in power stage 4-24
Overflow of target position preset memory 4-12
Overvoltage in power stage 4-38
P
P0 5-44
P1 5-44
P2 5-44
P3 5-44
Parameter calculation error (->S-0-0022) 5-9
Parameter default value erroneous (-> S-0-0021) 5-21
Parameter limit error (->S-0-0022) 5-8
Parameters not copyable 5-20
Parking axis command 5-25
Parking axis only while drive is disabled 5-25
Phase switching without ready signal 4-18
Phase synchr. lagless, encoder 1, real master drive 5-35
Phase synchr. lagless, encoder 1, virtual master drive 5-34
Phase synchr. lagless, encoder 2, virtual master drive 5-35
Phase synchronization, encoder 1, real master drive 5-34
Phase synchronization, encoder 1, virtual master drive 5-34
Phase synchronization, encoder 2, virtual master drive 5-34
PL 5-44
PL Load parameter default values 4-3
Position control lagless, feedback 2 5-32
Position data scaling error 5-10
Position limit reached during jog 4-40
Position mode lagless, encoder 1 5-32
Position mode with encoder 1 5-31
Position mode with encoder 2 5-32
Position of data record in MDT (S-0-0009) even 5-5