SERVICE PROGRAM 9 March 2004
5-30
4903*
ADS Level
[0
∼
255 /
252
/ 1/step]
4903 1 Adjusts the ADS level.
4904*
ADS Lower Limit
[0 ∼ 255 / 80 / 1/step]
4904 1 Adjusts the ADS lower limit.
4905* ADS Level [0 = All / 1 = One]
4905 1
Checks the whole area (0 = All) or the specific areas (1 = One) to adjust the ADS
level. The specific areas are as follows:
•
ADF:
±
37.5 mm from the center
• Platen Cover: 15 to 90 mm from the left edge
4921*
Image Adj Selection
Copy [0 ~ 10 /
0
/ 1/step] 4921 1
Selects which mode the settings from SP4-922 to SP4-932 are used for.
0 = None 1 = Text 1 2 =Text 2 3= Photo 1
4 = Photo 2 5 = Photo 3 6 = Special 1 7 = Special 2
8 = Special 3 9 = Special 4 10 = Special 5
Fax [0 ~ 5 / 0 / 1/step] 4921 2
Selects which mode the settings from SP4-922 to SP4-932 are used for.
0 = None 1 = Text 1 2 =Text 2 3= Photo 1
4 = Photo 2 5 = Special 1
Scanner [0 ~ 4 /
0
/ 1/step] 4921 3
Selects which mode the settings from SP4-922 to SP4-932 are used for.
0 = None 1 = Text 1 2 =Text 2 3= Photo 1
4 = Photo 2
4922* Scanner Gamma [0=System default/1=Text/2=Photo]
4922 1 Copy
4922 2 Fax
4922 3 Scanner
Selects “text” or “photo” as the priority output mode.
This setting is applied to all image processing
modes of SP4-921.
Notch Selection 4923*
Selects the value of the center ID adjustment notch for the ID adjustment LEDs.
• Normally the center notch is 3 (range 1-5). If –1 is selected, each notch shifts
down (becomes lighter). If +1 is selected, each notch shifts up (becomes darker).
• This setting is applied to all image processing modes of SP4-921.
4923 1 Copy
4923 2 Fax
4923 3 Scanner
[–1 = Light /
0
= Normal / +1 = Dark]
To Next Page
Loading...
