9 March 2004 SERVICE PROGRAM
5-39
Service
Tables
5840
* IEEE 802.11b
SSID 5840 4*
Specifies a unique ID (up to 32 characters long) to identify the device when it is
operating in an area with another wireless LAN network.
Channel MAX [1~14 /
14
/ 1/step] 5840 6*
Sets the maximum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location. The
default settings are set for the maximum end of the range for each area. Adjust the
upper 4 bits to set the maximum number of channels. This program is displayed
only when the optional IEEE 802.11b interface is installed.
Channel MIN [1~14 /
14
/ 1/step] 5840 7*
Sets the minimum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location. The
default settings are set for the minimum end of the range for each area. Adjust the
lower 4 bits to set the minimum number of channels. This program is displayed only
when the optional IEEE 802.11b interface is installed.
00
: Key #1 0000 0000
01: Key #2 (Reserved)
0000 0001
10: Key #3 (Reserved)
0000 0010
WEP Key Select
11: Key #4 (Reserved)
0000 0011
5840 11*
Selects the WEP key. [00~11 / 00 / 1 binary]
SSID 5840 18*
Checks that the specified SSID is correct. This SP is effective only when the
optional IEEE 802.11b interface is installed. This SP sees if any incorrect character
is included in the SSID that is input from the operation panel. (The characters out of
the range from 0x20 to 0x7e are incorrect.) The result is returned to the operation
panel:
2: OK, 3: NG
NOTE:
This SP is necessary for the models that support the multi-function panel,
since this panel can input incorrect characters.
WEP Mode
0
: Max. 64-bit (10 characters)
1: Max. 128-bit (10, 26 characters)
5840 20*
Determines the operation mode of the WEP key. This program is displayed only
when the optional IEEE 802.11b interface is installed.
5842
Net File Analysis
5842 1*
Specifies the output mode for debugging of each net file process. The 8th bit is
reserved. The 7th bit is the switch of debugging output for each module.
To Next Page
Loading...
