READ THIS FIRST
Important Safety Notices
Prevention of Physical Injury
1. Be sure that the power cord is unplugged before disassembling or assembling parts of the
copier or peripherals.
2. The wall outlet should be near the copier and easily accessible.
3. Note that electrical voltage is supplied to some components of the copier and the paper tray
unit even while the main power switch is off.
4. If any adjustment or operation check has to be made with exterior covers off or open while the
main switch is turned on, keep hands away from electrified or mechanically driven
components.
5. If you start a job before the copier completes the warm-up or initializing period, keep hands
away from the mechanical and electrical components until job execution has started. The
copier will start making copies as soon as warm-up or initialization is finished.
6. The inside and the metal parts of the fusing unit become extremely hot while the copier is
operating. Be careful to avoid touching those components with your bare hands.
Health Safety Conditions
Toner and developer are nontoxic, but getting either of these into your eyes may cause temporary
eye discomfort. Try to remove with eye drops or flush with water. If material remains in eye or if
discomfort continues, get medical attention.
Observance of Electrical Safety Standards
The copier and its peripherals must be installed and maintained by a customer service
representative who has completed the training course on those relevant models.
Keep the machine away from flammable liquids, gases, and aerosols. A fire or an
explosion might occur if this precaution is not observed.
To Next Page
Loading...
Need help?
Power
System Memory
Paper Handling
Weight and Dimensions
