Ricoh Aficio MP 301SPF Service Manual

Paper Tray Unit
SM 1 D661
Paper Feed
Unit PB1040
(D661)
1. REPLACEMENT AND ADJUSTMENT
1.1 PAPER TRAY UNIT
1.1.1 PAPER TRAY UNIT
If optional tray heater is not installed
1. Lift copier off the paper tray unit.
If optional tray heater is installed
1. Refer to section “Paper Tray Unit Heater” in the installation on the Field Service Manual, and
do following:
 Unscrew the ground line.
 Unclamp the heater harness clamps.
 Disconnect the heater harness clamps.
 Unwrap and remove the core.
2. Pull the relay harness down and out through the hole in the PSU bracket, and then pull it all
the way in through the hole at the rear of the (main) paper tray unit.
3. Lift the copier off the paper tray unit.
 To reinstall, refer to the procedure in section “Paper Tray Unit Heater” in the
installation on the Field Service Manual.

Ricoh Aficio MP 301SPF Specifications

Power

power requirements	120V, 60Hz, 8A
power consumption	Less than 1.1 kW
sleep mode power consumption	2.8 W

System Memory

system memory	1 GB RAM
hard disk drive	Optional 128 GB HDD
CPU	RM7035C – 533 MHz

Printer Specifications

output speed	Up to 31 ppm (Letter)
maximum print resolution	600 x 600 dpi
first copy time	6 seconds or less

Paper Handling

standard input capacity	250 sheets + 100-Sheet Bypass Tray
output capacity	250 sheets (internal tray)
document feeder original capacity	50 sheets (ARDF)

Scanner Specifications

scanning speed	31 ipm @ 300 dpi B/W
scanning resolution	100 to 600 dpi
scan area main	8.5 inches

Weight and Dimensions

width	19.0 inches
depth	17.7 inches
height	18.1 inches
weight	57.3 lbs.