Ricoh Aficio MP 301SPF Service Manual

Using SP Mode
D127/D128 5-6 SM
ROM/NEW What it means
ROM:
Tells you the number of the module and name of the version
currently installed. The first line is the module number, the second
line the version name.
NEW:
Tells you the number of the module and name version on the SD
card. The first line is the module number, the second line the
version name.
 Controller, engine and operation panel firmware cannot be updated at the same time.
It is recommended to update firmware modules one by one.
8. Touch "UpDate (#)" (or
) to start the update.
 The progress bar does not show for the operation panel firmware after you touch
"OpPanel". The power on key flashes on and off at 0.5 s intervals when the LCDC
firmware is updating. The power key flashes on and off at 3 s intervals when the
update is finished.
9. The "Update is Done" message appears on the operation panel after completing the updating.
The message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the "Update is Done" message or
follow the procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.
Error Messages
An error message shows in the first line if an error occurs during the download.
The error code consists of the letter "E" and a number. The example above shows error "E24"
displayed. For details, refer to the Error Message Table (see "Handling Firmware Update
Error").

Ricoh Aficio MP 301SPF Specifications

Power

power requirements	120V, 60Hz, 8A
power consumption	Less than 1.1 kW
sleep mode power consumption	2.8 W

System Memory

system memory	1 GB RAM
hard disk drive	Optional 128 GB HDD
CPU	RM7035C – 533 MHz

Printer Specifications

output speed	Up to 31 ppm (Letter)
maximum print resolution	600 x 600 dpi
first copy time	6 seconds or less

Paper Handling

standard input capacity	250 sheets + 100-Sheet Bypass Tray
output capacity	250 sheets (internal tray)
document feeder original capacity	50 sheets (ARDF)

Scanner Specifications

scanning speed	31 ipm @ 300 dpi B/W
scanning resolution	100 to 600 dpi
scan area main	8.5 inches

Weight and Dimensions

width	19.0 inches
depth	17.7 inches
height	18.1 inches
weight	57.3 lbs.