Programs
267
7
D Press [Program].
When no programs are registered, proceed to step
E
.
E Select a program number in which “Not Programmed” is shown.
If you make a mistake, press [Cancel] and select a program number again.
When you change a Keystroke Program, press [Yes] after pressing the program
number you want to change. If you make a mistake, press [No] and try again.
F Enter the program name, and then press [OK].
The standby display appears.
If the program name is already registered, the name is displayed. To change
the program name, press [Backspace] or [Delete All], and then try again.
You should register the program name.
To cancel a program, press [Cancel]. The display returns to that of step
E
.
Note
❒ Use the same procedure to register and change programs. In step
E
, select
the program number you want to change.
❒ For the maximum number of Keystroke Programs you can register, see
“Maximum Values”.
❒ For the maximum number of characters you can enter for a program name,
see “Maximum Values”.
❒ For the maximum number of destinations you can register to a Keystroke
Program, see “Maximum Values”.
❒ The method of registering or changing programs for the copy function is
different from that of the fax function.
To Next Page
Loading...
