Connecting the Machine
13
1
• For Mac OS:
Mac OS supports only the
standard USB port. If USB 2.0
is used with a Mac OS, only a
speed equal to that of USB 1.1
is possible.
Connecting to the Ethernet
Interface
The network interface board supports
10BASE-T or 100BASE-TX connec-
tions.
Important
❒ Before making the connection, touch
the metallic part to ground yourself.
A
AA
A
A core for the Ethernet cable is
supplied with this machine.
Make a loop at the end of the Eth-
ernet cable, and then attach the
core as shown below.
B
BB
B
Turn off the main power switch.
Important
❒ Make sure the main power is
off. See "Turning On the Pow-
er", General Settings Guide.
C
CC
C
Connect the Ethernet interface ca-
ble to the 10BASE-T/100BASE-TX
port.
D
DD
D
Turn on the main power switch.
1.
Indicator (green)
Remains green when the machine is
properly connected to the network.
2.
Indicator (yellow)
Turns yellow when 100 BASE-TX is
operating. Turns off when 10 BASE-T
is operating.
AEW017S
AEW012S
ZKRH050E
MartiniC25-EN-Pref-F_FM_ZF.book Page 13 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
