Ricoh DSm651 - Devicename; Dhcp

Monitoring and Configuring the Printer
86
4
btconfig
Use the "btconfig" command to make
Bluetooth™ settings.
❖
❖❖
❖ View settings
Bluetooth™ settings are displayed.
msh> btconfig
❖
❖❖
❖ Mode settings
You can set the Bluetooth™ opera-
tion mode to {private} or {public}.
msh> btconfig {private |
public}
• The default is {public}.
devicename
Use the "devicename" command to
display and change the printer name.
❖
❖❖
❖ View settings
msh> devicename
❖
❖❖
❖ Printer name configuration
msh> devicename name
“string”
• Enter a printer name using up
to 31 alphanumeric characters.
• Set single names for each printer.
❖
❖❖
❖ Printer name initialization
msh> devicename clear name
• Reset the printer name to its de-
fault.
dhcp
Use the "dhcp" command to config-
ure DHCP settings.
❖
❖❖
❖ View settings
The following command displays
the current DHCP settings.
msh> dhcp
❖
❖❖
❖ Configuration
You can configure DHCP.
msh> dhcp “interface_name”
{on|off}
• Click {on} to enable dhcp. Click
{off} to disable DHCP.
• If the DNS server address and
domain name are obtained from
DHCP, be sure to click {on}.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only when
the IEEE 802.11b interface is in-
stalled.
❖
❖❖
❖ Current interface priority configura-
tion display
msh> dhcp priority
❖
❖❖
❖ Interface priority configuration
msh> dhcp priority “interface
_name”
• You can select which interface
has DHCP parameter priority.
• Priority settings are available
when multiple interfaces are in-
stalled.
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan
IEEE 802.11b interface