Ricoh DSm651 - Job Preset

Basic Procedure
21
2
A
AA
A
Press {
{{
{Face Up}
}}
} key.
B
BB
B
Place originals, and then press the
{
{{
{Start}
}}
} key.
Job Preset
You can make settings for the next
copy job while copying is in progress.
If a long copy job is in progress and
you do not want to wait for it to fin-
ish, you can use this function to make
settings for the next copy job in ad-
vance. When the current copy job fin-
ishes, the next job begins automatically.
Reference
See “Job List”, General Settings
Guide
A
AA
A
Press [Next Job] when "
Copying
" is
displayed.
B
BB
B
Make settings for the next copy
job.
C
CC
C
Place the originals in the ADF,
and then press the {
{{
{Start}
}}
} key.
All originals are scanned.
After the current copy job, the next
job starts automatically.
Note
❒ Each job stored is allocated a job
number that is displayed on the
Reserved Job screen.
❒ To switch the display to the cur-
rent copy job press [Reserved
Job], followed by [Printing], and
then [Exit]
Editing Job Preset
You can check and change the con-
tents of preset jobs. You also can de-
lete preset jobs.
A
AA
A
Press [Reserved Job].
B
BB
B
Select the number of the job you
want to check or change.
C
CC
C
Press [Check/Change Job].
The contents of the job are dis-
played.
To check the job contents
A
AA
A
Check the contents of the job.
B
BB
B
Press [Confirmed].
The display returns to the Re-
served Job screen.
MartiniC2_EN_Copy-F1_FM.book Page 21 Tuesday, July 27, 2004 1:43 PM