Ricoh DSm651 - Setting up as a Remote Printer (Netware 4.X, 5;5.1, 6;6.5)

Using a Printer Server
62
3
V
VV
V
Start the print server by entering
the following from the console of
the NetWare server.
If the print server is in operation,
quit and restart it.
❖
❖❖
❖ To quit
CAREE: unload pserver
❖
❖❖
❖ To start
CAREE: load pserver
print_server_name
Note
❒ If the printer works as config-
ured, the message "Waiting for
job" appears.
Setting Up as a Remote Printer
(NetWare 4.x, 5/5.1, 6/6.5)
Follow the procedure below to use
the printer as a remote printer under
NetWare 4.x, 5/5.1 and 6/6.5.
Important
❒ To use the printer as a remote print-
er under NetWare 4.x, 5/5.1, 6/6.5,
set it to NDS mode.
❒ Do not use the printer as a remote
printer when Pure IP is used.
Setting up using NIB Setup Tool
A
AA
A
Log on to the file server as an ad-
ministrator or administrator
equivalent.
B
BB
B
Start NIB Setup Tool from [Start]
menu.
C
CC
C
Click [Property Sheet], and then
click [OK].
D
DD
D
Select a printer you want to con-
figure.
E
EE
E
Click [NetWare].
F
FF
F
In the [Logon Mode] area, click [File
Server Mode] or [NDS mode].
If [File Server Mode] is selected, the
network connection is established
based on the string you entered.
If [NDS mode] is selected, the net-
work connection is established
based on the string you entered.
G
GG
G
In the [Print Server Name(P):] box,
enter the name of the print server.
Use the same print server name in
NWadmin. Enter up to 47 alpha-
numeric characters.