Settings You Can Change with User Tools
57
4
❖
❖❖
❖ Z-fold Position
You can change the Z-fold positon according to the paper size.
Note
❒ Default:
• Metric version
• A3: 2mm
• B4 JIS: 2mm
• A4: 2mm
• 11"×17": 2mm
• 8
1
/
2
"×14": 2mm
• Inch version:
• A3: 0.1"
• B4 JIS: 0.1"
• A4: 0.1"
• 11"×17": 0.1"
• 8
1
/
2
"×14": 0.1"
Output tray settings
Limitation
❒ You cannot interrupt the current stapling job even when a stapling job is spec-
ified with a different function.
❒ When the optional finisher is installed and stapling or shift-sorting is speci-
fied, the job will be delivered to the finisher shift tray regardless of the output
tray specified.
Tray Paper Settings
❖
❖❖
❖ Paper Tray Priority: Copier (Copier/Document Server)
You can specify the paper tray from which paper is to be supplied.
Note
❒ Default: Tray 1
❖
❖❖
❖ Paper Tray Priority: Printer (Printer)
You can specify the paper tray from which paper is to be supplied.
Note
❒ Default: Tray 1, LCT
❒ The default tray switches to LCT if the optional large capacity tray (LCT)
is installed.
MartiniC2_ENzen_F_pre_FM.book Page 57 Tuesday, July 27, 2004 1:24 PM
To Next Page
Loading...
