If Your Machine Does Not Operate As You Want
107
4
Display During Connect Copy
This tray is un-
available because
the sub-machine
does not have the
same paper set-
ting(s).
Paper tray settings on the
two machines do not
match.
Make the same settings on both ma-
chines.
No stamp data in
the sub-machine.
The stamp data on the sub-
machine has been deleted.
Program the stamp again on the
sub-machine.
Cannot print from
sub-machine. Sub-
machine will be
disconnected.
Sub-machine has stopped
because of a power failure
or communication error.
Continue copying using the main
machine.
Z-fold is avail-
able only when
Sort mode is se-
lected in Connect
Copy.
Sort has not been selected
with Z-fold.
Select the Sort function.
Problem Causes Solutions
[] is not dis-
played.
The main power of the sub-
machine is off.
Turn the main power of the sub-ma-
chine on.
Functions that cannot be
used with Connect Copy
are selected on the main
machine (such as storing or
copying the first page of a
document in the Document
Server).
Cancel the functions selected on the
main machine.
The main machine is in In-
terrupt mode.
Press the {
{{
{Interrupt}
}}
} key on the sub-
machine to exit Interrupt mode.
The Connect Copy Key
Display setting is Off.
Select [Display] for the Connect Copy
Key Display setting.
The cable connecting the
two machines is damaged.
Contact your service representative.
The L
LL
L is lit. Follow the instructions displayed.
[] appears faded.
Functions that cannot be
used with Connect Copy
have been set.
Press the {
{{
{Clear Modes}
}}
} key to clear
the settings.
Message Causes Solutions
MartiniC2_EN_Copy-F1_FM.book Page 107 Tuesday, July 27, 2004 1:43 PM
To Next Page
Loading...
