127
6. Remarks
Dos And Don'ts
WARNING:
CAUTION:
• Do not turn off the main power
switch while the On indicator is lit
or blinking. This may cause dam-
age to the hard disk or memory.
• Do not touch areas on or around
the fusing unit. These areas get hot.
•
After scanning originals continuous-
ly, the exposure glass may become
warm—this is not a malfunction.
• When you use this machine for a
long time in a confined space with-
out good ventilation, you may de-
tect an odd smell. To keep the
workplace comfortable, we recom-
mend that you keep it well venti-
lated.
• The area around the ventilation
hole may become warm. This is
caused by exhaust air and is not a
malfunction.
• Do not turn off the power when
the machine is in operation.
• The machine might fail to produce
good copy images if condensation
forms inside due to rapid tempera-
ture change.
• Do not open the covers of the ma-
chine when it is in operation. If you
do, misfeeds might occur.
• Do not move the machine when
the power is on.
• If you operate the machine im-
properly or a failure occurs, set-
tings might be lost. Be sure to make
a note of your machine settings.
• The supplier shall not be liable for
any loss or damage resulting from
a failure of the machine, loss of set-
tings, or use of the machine.
• Keep the machine away from
flammable liquids, gases, and
aerosols. A fire or an electric
shock might occur.
• Unplug the power cord from the
wall outlet before you move the
machine. While moving the ma-
chine, you should take care that
the power cord will not be dam-
aged under the machine.
MartiniC2_ENzen_F_pre_FM.book Page 127 Tuesday, July 27, 2004 1:24 PM
To Next Page
Loading...
