Ricoh DSm651 - Changing the Port Settings for Smartdevicemonitor for Client

Using the SmartDeviceMonitor for Client Port
31
2
S
SS
S
Click [Finish] in the installation completion dialog box.
A message about restarting the computer may appear. Restart the computer
to complete installation
Note
❒ To stop installation of the selected software, click [Cancel] before installa-
tion is complete. Restart the computer and reinstall other software pro-
grams or printer drivers.
Reference
A message appears if there is a newer version of the printer driver already
installed. If there is, you cannot install the printer driver using Auto Run.
If you still want to install the printer driver, use[Add Printer]. See p.57 “If a
Message Appears during Installation”.
Changing the Port Settings for SmartDeviceMonitor for Client
Follow the procedure below to change the SmartDeviceMonitor for Client set-
tings, such as TCP/IP timeout, recovery/parallel printing, and printer groups.
Note
❒ There are no settings for NetBEUI protocol.
Windows 95/98:
A
AA
A
Open [Printers] window from [Start] menu. .
B
BB
B
In the [Printers] window, click the icon of the printer you want to use. On
the [File] menu, click [Properties]
C
CC
C
Click the [Details] tab, and then click [Configure Port].
The [Port Settings] dialog box appears.
Windows 2000 / Windows NT 4.0:
A
AA
A
Open [Printers] window from [Start] menu. .
B
BB
B
In the [
Printers
] window, click the icon of the printer you want to use. On
the [
File
] menu, click [
Properties
]
C
CC
C
On the [Ports] tab, click [Configure Port]
The [Port Settings] dialog box appears.
MartiniC25-EN-Pref-F_FM_ZF.book Page 31 Tuesday, July 27, 2004 11:51 AM