Troubleshooting
104
5
Replacing Toner
• Open the front cover of the machine.
• Pull out the lever under the toner bottle to-
ward you 90°.
• Raise the green lever, and then gently pull
out the toner bottle.
• Hold the new bottle horizontally, and then
shake it five or six times without removing
the outer cap.
• Remove the outer cap.
Note
❒ Do not remove the inner cap.
• Place the toner bottle in position, then
push it in until the green lever clicks.
Note
❒ If you cannot get it to click in, pull out
the toner bottle a little, slightly rotate it
to the right by 10 – 20°, then try again.
• Return the lever under the toner bottle to
its original position.
• Close the front cover of the machine.
ZGVY1060E
ZGVY1070E
ZGVY1080E
ZGVY1090E
ZGYV1100E
ZGVY1200E
MartiniC2_ENzen_F_pre_FM.book Page 104 Tuesday, July 27, 2004 1:24 PM
To Next Page
Loading...
