Placing Originals
15
1
Placing Originals on the
Exposure Glass
Reference
For related default settings, see
p.135 “Eject Copy Face Up/Down
in Glass Mode”.
A
AA
A
Lift the exposure glass cover or
the ADF.
Important
❒ Do not lift the exposure glass
cover or the ADF forcefully.
Otherwise, the ADF cover
might open or be damaged.
Note
❒ Be sure to lift the exposure glass
cover or ADF more than 30°.
Otherwise, the size of the origi-
nal might not be detected cor-
rectly.
B
BB
B
Place the original face down on
the exposure glass. It should be
aligned with the rear left corner.
1.
Positioning mark
2.
Scale
Note
❒ Start with the first page to be
copied.
C
CC
C
Lower the exposure glass cover or
ADF.
Placing Originals in the Auto
Document Feeder
Settings should be made accordingly
in the following situations:
❖
❖❖
❖ When placing originals consisting of
more than 100 pages:
p.16 “Batch”
❖
❖❖
❖ When placing originals one by one:
p.17 “SADF”
❖
❖❖
❖ When placing originals of the same
width but different sizes:
p.17 “Placing originals of mixed
sizes”
❖
❖❖
❖ When placing custom size originals:
p.18 “Placing custom size origi-
nals”
Note
❒ Do not stack originals above the
limit mark on the side guide of the
ADF.
❒ The last page should be on the bot-
tom.
❒ When you copy 2-sided originals,
both front and back sides of each
original are scanned at once.
❒ Do not place objects on the sensors
or cover them with your hands, or
the original size may not be detect-
ed properly. Also, do not place
anything on the exposure glass
cover as this could cause a mal-
function.
MartiniC2_EN_Copy-F1_FM.book Page 15 Tuesday, July 27, 2004 1:43 PM
To Next Page
Loading...
