G147 5-18 SM
Displays the GAIN value used to calculate the on time for the toner supply motor.
Image Pixel Cnt Image Pixel Count
005
Displays the image pixel count.
Trans Curr Adj Transfer Current Adjustment
2301
Adjusts the current applied to the transfer belt during printing the 5 phases listed
below.
Image Face 1st Side of Paper
001
Printing the first side of the paper (image area).
If the user uses thicker paper, the current may have to be increased to ensure
sufficient transfer of toner.
[20 ~ 100 μA / 45 / 1 μA step]
Image Back 2nd Side of Paper
002
Printing the second side of the paper (image area) during duplex printing.
[20 ~ 100 μA / 40 / 1 μA step]
Lead Edge Face Leading Edge. Face
003
Printing at leading edge of the paper.
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
[20 ~ 100 μA / 45 / 1 μA step]
Img Face Bypass Image Face By-pass (By-pass Feed)
004
Printing from the by-pass tray (image area).
If the user normally feeds thicker paper from the bypass tray, use a higher setting.
[20 ~ 100 μA / 45 / 1 μA step]
Lead Face Bypass Leading Edge By-pass Feed
005
Printing at the leading edge of paper fed from the by-pass tray.
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
To Next Page
Loading...
