Ricoh G147 - Page 212

G147 5-22 SM
reduced to 50 ms.
Tst Pattern Den Print Density for Test Pattern
2913
[0 ~ 15 / 15 / 1]
Sets the print density for the patterns printed with SP2-902-3.
2914 Process Ctrl Set Process Control Setting
C alpha [0 ~ 400 / 150 / 10V step]
001
Adjusts the charge roller voltage used when paper with a small width is fed from
the by-pass tray. The paper width below which the correction starts depends on
the value of SP2-309-1.
Use this SP when an image problem (such as white spots at the center of black
dots or breaks in thin black lines) occurs when paper with a small width is fed from
the by-pass feed tray.
C beta [0 ~ 400 / 0 / 10V step]
002
Adjusts the charge roller voltage used when paper with a small width is fed from
the by-pass tray. The paper width below which the correction starts depends on
the value of SP2-309-2.
Use this SP when an image problem (see 2-914-1) occurs when paper with a
small width is fed from the by-pass feed tray.
B gamma [0 ~ 300 / 200 / 10V step]
003
Adjusts the development bias used when paper with a small width is fed from the
by-pass tray. The paper width below which the correction starts depends on the
value of SP2-309-1.
Use this SP when an image problem (see 2-914-1) occurs when paper with a
small width is fed from the by-pass feed tray.
B delta [0 ~ 300 / 50 / 10V step]
004
Adjusts the development bias used when paper with a small width is fed from the
by-pass tray. The paper width below which the correction starts depends on the
value of SP2-309-2.