SM 5-25 G147
Service
Tables
Image Dens Adj Image Density Adjustment
2974
[1 ~ 5 / 3 / 1 step]
Adjusts image density. Changing this setting adjusts development bias and ID
sensor output voltage that in turn raises or lowers image density.
Toner End Time Toner End Detection ON Time
2975
[0 ~ 2,000 / 0 / 10 s step]
Sets a time limit for issuing the toner near end warning on the operation panel.
The time may need to be shorter for customers who run especially large print jobs
(working at night, for example) to ensure earlier warning of the toner near end
condition so toner out does not interrupt a long job.
0: Normal end detection (90 sheets after near-end detected (SP2213)
T Bottle On Cnt Toner Bottle Total On Time
2976
[0 ~ 2,000,000 / 0 / 1 ms step]
Displays the total ON time of the toner supply motor, calculated from when the
toner bottle was replaced. Use this to check that the toner end count (SP2975) is
working properly.
When SP2975 is set to any value other than “0”, this value is displayed when it
matches the setting of SP2975. When SP2975 is set to “0”, SP2976 is disabled.
SP2976 is automatically set to zero by toner end recovery.)
Charge Counter
2980
[0 ~ 1000000 / 0 / 1 step]
Sets the number of pages to print after toner and carrier initialization before the
charge input is increased to compensate for deterioration over time in the polarity
of the carrier.
The strength in the polarity of the carrier in the toner will eventually decrease and
cause lower charge output. Setting the charge output to increase after a specified
number of copies can compensate for this effect.
To Next Page
Loading...
