SM 1-11 G147
Installation
5. On the side of the machine, remove the three small covers [4].
6. Remove the two larger covers [5].
7. Remove the cover [6] (
x 1).
8. Remove the cap [7].
9. If an optional finisher is to be installed, attach two mylars [8] to the bridge unit.
10. Remove the cover [9].
11. Install the bridge unit [10] (
x 2).
12. Connect the bridge unit I/F harnesses [11] (
x 2).
13. Install the connector cover [12].
To Next Page
Loading...
