Ricoh LI-MF1 M126 - Page 184

4. To test the flatbed cover closed sensor, lift the flatbed cover. The 0 next to the F will change to 1.
Also check the actuator (B) to ensure it is functioning properly.
5. To test scanner sensor 1 press on the tab (C). The 0 next to the 1 will change to 1 if the sensor is
working properly.
6. To test scanner sensor 2 press on the tab (D). The 0 next to the 2 will change to 1 if the sensor is
working properly.
5. System Maintenance
182
5