Error Description Action
202.01
Exit sensor never broke on the trailing edge
of the sheet at the exit sensor.
Open the rear door, and inspect the flag
on the exit sensor. The flag is located
behind the fuser exit rollers, about mid
machine. If the flag does not rotate freely
or has no spring action, then replace the
fuser (
p.62 "Fuser Removal").
202.02
Exit sensor never broke from sheet ahead of
page heading toward the exit sensor.
202.06 Exit sensor bounced
202.13
Exit sensor covered, media not expected
(media not in machine during warm-up)
202.25
Exit sensor never broke from the sheet ahead
of the page heading toward the exit sensor
when feeding out the media detected during
warm-up.
202.26
Trailing edge never cleared exit sensor when
feeding out media that was detected during
warm-up.
Open the rear door, and inspect the flag
on the exit sensor. The flag is located
behind the fuser exit rollers, about mid
machine. If the flag does not rotate freely
or has no spring action, then replace the
fuser ( p.62 "Fuser Removal").
202.32
Long media or shingled multi feed stopped
before sending to duplex.
Check the paper setting and correct if
needed. While feeding along the media,
and immediately after it enters the output
bin, open the rear door and obscure the
trailing edge and the sensor flag. If there
is slippage in the exit guide, then replace
the exit guide ( p.103 "Rear Exit Guide
Assembly with Sensor and Reversing
Solenoid Removal").
Messages and Error Codes
215
To Next Page
Loading...
