10. Connect the USB cable [B] to the smart card reader/writer.
• Make a loop with the USB cable when connecting.
11. Attach the smart card reader cover on the smart card reader/writer.
12. Attach the clamps [A] on the right side of the scanner unit, and then route the USB cable
( x3).
13. Route the USB cable along the rear side of the scanner unit ( x1).
• Adjust the USB cable by making loops if the USB cable has too much slack.
Smart Card Reader Built-in Unit Type M2 (D739-36)
163
To Next Page
Loading...
Need help?
General
