SC No. Level Error Name/Error Condition/Major Cause/Solution
SC503-33 B
3rd Tray Paper Overload Error (LCIT)
During tray initialization, both the upper limit and lower limit are detected
3 times consecutively.
(Up to 2 times consecutively, LCIT transmits "tray set fault" to the main
machine)
• Paper overload
• Paper set fault
• Limit sensor error/connector missing
• Lower limit sensor error/connector missing
• Harness broken
• Bank control board defective
• Foreign matter, such as paper scrap, is caught inside the right tray
• Reset the paper
• Remove the foreign matter
• Reset the connector
• Replace the harness
• Replace the sensor
• Replace the control board for the optional paper feed tray
5. Troubleshooting
486
To Next Page
Loading...
