SC No. Level Error Name/Error Condition/Major Cause/Solution
SC503-34 B
3rd Tray Paper Position Error (LCIT)
During left/right tray set, or when power is switched ON, or when
transfer is complete, "open" is detected 3 times consecutively by end
fence open/close detection.
(Up to 2 times consecutively, LCIT transmits "tray set fault" to the main
machine)
• Paper set fault (paper is offset from position for pushing end fence)
• Foreign matter entry (foreign matter is caught in the position for
pushing end fence)
• End fence open/close sensor error/connector missing
• Harness broken
• Bank control board defective
• Reset the paper
• Remove the foreign matter
• Reset the connector
• Replace the harness
• Replace the sensor
• Replace the control board for the optional paper feed tray
Service Call 501-584
487
To Next Page
Loading...
