Ricoh Printer/Scanner Unit Type 8000 Network Guide

Monitoring and Configuring the Printer
82
2
keyphrase
[ “phrase” ] val
[1|2|3|4]
You can specify
the WEP key when
entering in ASCII.
With a 64-bit WEP,
you can use 10 digit
hexadecimals.
With a 128-bit
WEP, you can use
26 digit hexadeci-
mals.
Up to four WEP
keys can be regis-
tered. Specify the
number to be reg-
istered with “val”.
When a WEP is
specified by key
phrase, the WEP
specified by key is
overwritten.
To use this func-
tion, set the same
key number and
WEP key for all
ports that transmit
data to each other.
You can omit the
numbers with
“val”. The key
number is set to1
when making
these omissions.
The default is
blank.
encval [1|2|3|4] You can specify
which of the four
WEP keys is used
for packet encod-
ing. “1” is set if a
number is not
specified.
wepauth
[open|shared]
You can set an au-
thorization mode
when using WEP.
The specified value
and authorized
mode are as follows:
open: open system
authorized (default)
shared: shared key
authorized rate
Parameter Value configured
rate [auto|11m|
5.5m|2m|1m]
You can set the
IEEE 802.11b trans-
mitting speed.
The speed you
specify here is the
speed at which
data is sent. You
can receive data at
any speed.
auto: automatical-
ly set (default)
11m: 11 Mbps
fixed
5.5m: 5.5 Mbps
fixed
2m:2 Mbps fixed
1m: 1 Mbps fixed
security
{none|wep|wpa}
You can specify
the security mode.
none: No encryp-
tion(default)S
wep: WEP encryp-
tion
wpa: WPA encryp-
tion
wpaenc {tkip|ccmp} You can specify
WPA encryption
key when using
WPA encryption.
tkip: TKIP (de-
fault)
ccmp: CCMP
(AES)
wpaauth
{wpapsk|wpa}
You can specify
the WPA authenti-
cation mode when
using WPA en-
cryption.
wpapsk: WPA-
PSK authentica-
tion(default)
wpa: WPA(802.1X)
authentication
Parameter Value configured

Ricoh Printer/Scanner Unit Type 8000 Specifications

General

Brand	Ricoh
Model	Printer/Scanner Unit Type 8000
Category	All in One Printer
Language	English