1.Detailed Descriptions
44
Staple Near-End Detection
A Staple Near-End Detection function has been added.
The finisher software counts the number of staples used. When the number of remaining staples drops
below the near-end threshold, a Near-End notification is sent to the machine and a banner prompting
staple replenishment appears on the operation panel.
You can check the remaining number of staples in [Mach./Applic. Stat] tab on the [Check Status]
screen.
Staple Use Counter
• The staple use counter in the EEPROM counts the number of staples used. (Its initial value is 0.)
• After the counter has detected that the staples have run out (End), it is reset when it detects
staples (= replenished).
• Staples used in the End status are not counted.
Number of Remaining Staples [Maximum number - Counted Number of Staples Used]
The remaining number of staples is logged in SP6-795-002 / SP6-796-002 (Staple N.E. Setting: Staple
Remaining Setting). You can also change the remaining number of staples on this counter by changing
the value.
Near-End Threshold
The near-end threshold can be changed in SP6-795-001 / SP6-796-001 (Staple N.E. Setting: Near-End
Threshold). Depending on the model, the initial value is as follows:
• SR3280/SR3290: 800 corner staples and 300 booklet staples
• SR3270: 500 staples to be used for both corner and booklet stapling
• SR3260: 500 corner staples
Control
If the remaining number of staples (SP6-795-002/SP6-796-002) drops below the near-end threshold,
the near-end status is notified to the machine.
To correctly count the actual remaining number of staples, instruct the customer to do as follows:
To Next Page
Loading...
