64 ProSYS User Guide
Quick
Key
Function Description
1
Walk Test
Enables the engineer or the Grand Master to easily
test and evaluate the operation of selected zones in
your system
1. Full walk test: The test will display the detected
zones and type of detection.
2. Quick walk test: The test will display the undetected
zones.
2
Accessory
Versions
Get the software version of BUS zones, power supply,
sounder and GSM/GPRS module.
3
Get ACM
IP
View the ACM IP address. Required for establishing
remote communication for U/D through the IP network
4
Prepaid
SIM
When using Pre-paid SIM cards, these options are
used to receive information regarding the SIM card
credit level. For detailed information, refer to the
manuals supplied with the GSM/GPRS module.
5 Access Code
1
Update
Codes
Sets, changes, and deletes user codes, as described
on page 38.
2
Authority
Links user codes with Authority Levels, as described
on page 41.
3 Partition
Assigns partitions to users by Grand master.
4
User label
Assigns labels to users (10 characters long). These
labels will be presented in the event log. (GM code
Only)
5
Prox Tag
Assigns user codes to proximity tags, which are used
with proximity keypads to set and unset the system,
as described on page 56.
6
Dual Code
If defined by your engineer, the system can be
configured to be unset only by dual codes, for high
security. Up to 16 pairs of codes can be defined. The
time between entering the two user codes is 60
seconds. Users with Authority Levels of Cleaner, Set
Only and Guard cannot be used to perform the dual
Code unsetting.
6 Clocks
1
System
Time
Enables the setting of the system time, as described
on page 46.
2
System
Date
Enables the setting of the system date, as described
on page 46.
To Next Page
Loading...
