Robopac ROBOT S7 - 5.4. STEERING WHEEL RETURN SPEED ADJUSTMENT; 5.5. ADJUSTING THE HEIGHT OF THE FEELER WHEEL

ENG
INFORMATION ON ADJUSTMENTS
49
5.4. STEERING WHEEL RETURN SPEED ADJUSTMENT
Proceed as follows.
1. Perform “machine safe stop”.
2. Work on screw (A) to adjust the rudder retraction speed.
Important
The directional rudder retraction speed must not be too high in order to prevent any risk for human safety.
5.5. ADJUSTING THE HEIGHT OF THE FEELER WHEEL
Proceed as follows.
1. Perform “machine safe stop”.
2. Pull the knob (A), adjust the height of the wheel (C) using the knob (B) and release the knob (A) so that the pin
is correctly inserted into one of the holes.
3. To obtain greater heights, remove the knob (B), loosen the nut from the wheel (C) and refit them inverting their
positions.