Robopac ROBOT S7 - Page 68

68
INFORMATION ABOUT THE USE
ENG
J) Selector button: it is used to set the roping mode, the required rope size and the
number of performed turns.
Keep the button pressed to switch from “roping from the top” to “roping from the
bottom”.
− Icon (J1): it indicates roping from the top.
− Icon (J2): it indicates roping from the bottom.
K) Button: it is used to set the film stretch value
L) Button: Allows to set the ergonomic upstroke of the carriage
M) Button: Allows to set the film pre-stretch value
Present only in the PVS carriage