Important
If there is the optional automatic cutting unit, this phase will be automatically performed.
Information valid only for “feeder cycle” wrapping mode.
− When the machine stops in the pallet upper section, position the TOP sheet (do not cut the film).
− Press the "Cycle Start" button (C).
The machine performs the wrapping and, at the end of the set cycle, it stops at the pallet base.
At the end of the wrapping phase, the machine can be stopped in “stand-by” mode or switched off.
− When the machine is in “stand-by” mode and it is not used for more than 15 minutes, the “energy saving”
operating status is automatically activated.
To restore the machine operation touch the display.
If the “Energy saving” function stays on for more than 60 minutes, the machine automatically turns off.
− Press the button (A) to switch off the machine voluntarily.
To Next Page
Loading...
