Robopac SPIROR HP - Page 70

SPIROR HP - DR
M) Product winding end time (tail).
This is the time that determines the
winding end position relative to the end
of the product.
|
Important
To rename the recipe, you must touch
key (A).
Upon viewing the keypad, follow the
instructions in section "Modifying
settings".
N) Key to enable/disable coating breakage
control.
Press to enable the function, press again
to disable it.
O) Key to enable/disable the outlet pressure
roller descent advance.
Press to enable the function when
machining short products.
Press again to disable the function.
P) Key to enable/disable heat sealing.
Press to enable the function, press again
to disable it.
In the (Q) area, the welder's closing time
is visible and adjustable.
|
Note
The (Q) area is present only if welding is
enabled by the (P) key.
English
70/95