Roche Diagnostics
B-6
Operator’s Manual · Version 3.4
5 Daily operation Cedex Bio analyzer
Introduction
Loss of sight
The intense light of the LEDs may severely damage you eyes. Do not stare into the LEDs.
Scanning equipment using LED technology is covered by the international standard
EN/IEC 60825-1 LED Safety: Class 1.
Incorrect results or damage to the analyzer due to wrong operation
Operators are required to have a profound knowledge of relevant guidelines and norms as
well as the information and procedures contained in the Operator’s Manual.
o Do not carry out operation and maintenance unless you have been trained by Roche
Diagnostics.
o Start all maintenance actions on the screen. Do not perform maintenance actions with-
out the assistance of the user interface.
o Carefully follow the procedures specified in the Operator’s Manual for the operation
and maintenance of the system.
o Leave maintenance that is not described in the Operator’s Manual to a trained service
representative.
o Follow standard laboratory practices, especially when working with biohazard material.
Incorrect results or damage to the analyzer due to dust and soiling
The user can leave the main cover open while the system is in Standby status or while the
analyzer is shut down. This can cause dust and dirt being collected in the cuvette ring,
which in turn might decrease the quality of the cuvettes.
Keep all covers closed. Open them only to perform operation actions.
To Next Page
Loading...
Need help?
General
