94 Rockwell Automation Publication 5094-UM001E-EN-P - April 2020
Chapter 6 Configure the Standard Module
Connection Category
The Connection category lets you complete the following tasks:
• Set the RPI rate. For more information on the RPI, see Data Types
Available with FLEX 5000 Standard I/O Modules on page 28.
• Set the connection type to use on the EtherNet/IP network.
For more information on unicast and multicast connections, see the
EtherNet/IP Communication Modules in 5000 Series Systems User
Manual, publication ENET-UM004
.
• Inhibit the module. For more information on how to inhibit the module,
see Module Inhibiting
on page 49.
• Configure whether a connection failure while the controller is in Run
module causes a major or minor fault.
TIP The Module Fault area of the Connection category is useful during module
troubleshooting. For more information on the Module Fault area, see
page 137
.
To Next Page
Loading...
