What to do if the Rockwell Automation Controller transport system responds but motors don't operate?
If the transport system responds to the host controller, but the motors are not operating, it might be due to an activated Digital I/O E-stop or interlock circuit. Ensure that all E-stops or interlocks configured for the paths where the motors are located are in the operate state.
Why does my Rockwell Automation MagneMotion 700-0871-00 Controller have intermittent communication with the host controller?
If you experience intermittent communication with the host controller of your Rockwell Automation Controller, first, ensure that all network cables are properly seated. Secondly, verify that there are no IP address collisions.
How to troubleshoot communication problems with multiple Rockwell Automation Controllers?
If you are experiencing communications problems with multiple Rockwell Automation Controllers, indicated by dropped ping messages, the cause could be faulty network cables or a network switch that cannot handle the traffic. Check all network wiring and hardware to ensure they are operating correctly.
What causes intermittent communication with motors on a Rockwell Automation Controller?
If you're having intermittent communication issues with the motors of your Rockwell Automation Controller, make sure that all network cables are properly seated.
How to fix incorrect time on Rockwell Automation Controller node controller logs?
If the node controller logs of your Rockwell Automation Controller do not show the correct time, it could be because the battery for the clock in the node controller has lost its charge. You can manually correct the time each time the node controller is powered up, or return the node controller to MagneMotion for repair. Alternatively, use the node controller web interface Set Clock function to set the time.
General| Brand | Rockwell Automation |
|---|---|
| Model | MagneMotion 700-0871-00 |
| Category | Controller |
| Language | English |
To Next Page