Specifications and Site Requirements
Site Requirements
84 MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
Lighting, Site
No special lighting is required for proper operation of the node controllers. Maintenance can
require a user-supplied service lamp (for example, a flashlight).
Floor Space and Loading
The location for each node controller must meet the minimum space requirements as defined
in the Mechanical Specifications on page 54 to make sure that there is proper clearance for
installation, operation, and servicing. The dimensions that are given are for the node control-
lers only. Make sure that there is adequate space around the equipment for operation and ser-
vice that is based on their needs.
Facilities
The facility is responsible for providing power as specified in Electrical Specifications on
page 64 to support proper operation of the node controllers. See Electrical Connections on
page 97 for all connections to the node controllers.
The facility is responsible for the main disconnect device between the node controllers and the
power source, making sure it complies with the appropriate facility, local, and national electri-
cal codes. Service to the node controllers must have the appropriate circuit breaker rating.
Service Access
The node controllers require adequate space for service access and for proper operation. Typi-
cal service space that is required for the node controllers is shown in Figure 4-4, Figure 4-5,
Figure 4-6, and Figure 4-9. Make sure that installation of the node controller is such that it
provides access to items required for service after installation, such as power and communica-
tion connections.
NOTE: The exclusion zones that are shown are for the node controllers only. Additional
exclusion zones may be required based on the design of the transport system.
To Next Page
Loading...
