Maintenance
Shipping
126 MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
Shipping
If a node controller must be shipped, either for return to MagneMotion or to another location,
it must be packaged properly to make sure it arrives undamaged. The following procedure
provides the correct method for handling and packaging node controllers for shipment.
Packing Procedure
When any node controllers are shipped, either for return to MagneMotion for service or to
another location, they must be properly packaged to make sure that they arrive undamaged.
The following procedure provides the correct method of handling and packaging the Magne-
Motion components for shipment.
NOTE: The original shipping packaging must be used when shipping MagneMotion compo-
nents. If the original packaging has become lost or damaged, contact MagneMotion
for replacements.
1. Turn off and disconnect all electrical power as detailed in Node Controller Shutdown
on page 111.
2. Disconnect all communications connections as detailed in Node Controller Shutdown
on page 111.
3. Make sure that the system or component has been properly decontaminated following
the facilities decontamination procedures. Follow all facility, local, and national proce-
dures for the disposal of any hazardous materials.
4. When shipping individual components, remove all components that will be shipped
(reverse the sequence to install the components) and see Shipping on page 126.
Shipping
1. Wrap, bag, and pack each component following standard packing procedures.
2. Use the container that the component was originally shipped in. Set the component
into the container and secure using the supplied packing material.
CAUTION
Electrical Hazard
Before beginning this procedure, the MagneMotion transport
system must be shut down following the procedure that is
provided in Node Controller Shutdown on page 111.
To Next Page
Loading...
