Introduction
Getting Started with the Node Controllers
26 MagneMotion
Rockwell Automation Publication MMI-UM013B-EN-P - April 2020
an easy method to verify proper operation and make adjustments such as refining the
control loop tuning.
NOTE: The NCHost TCP Interface Utility is for test and verification trials only. The
host controller must be used to control the transport system after verification
of functionality.
7. Configure the host controller (either a general-purpose computer or PLC) to control
the transport system as required to meet the material movement needs of the facility
where the system is installed. See the Host Controller TCP/IP Communication Proto-
col User Manual or the Host Controller EtherNet/IP Communication Protocol User
Manual.
To Next Page
Loading...
