Rohde & Schwarz CMW500 - Page 154

Remote Control
R&S
®
CMW500
138User Manual 1173.9463.02 ─ 06
●
RDY: Measurement has been terminated, valid results may be available. RDY cor-
responds to the SCPI trigger state IDLE.
●
RUN: Measurement running (after INITiate..., READ...), synchronization
pending or adjusted, resources active or queued (see Measurement Substates). RUN
corresponds to the SCPI trigger state INITiated.
Querying the main measurement state
The main measurement state can be queried using
FETCh:<FWA>:<context>:STATe? where <FWA> denotes the firmware application
and <context> is to be replaced by the name of the measurement.
Example: FETCh:GPRF:MEASurement:POWer:STATe? (possible response: RDY).
The relationship between measurement states and measurement control commands is
shown in the following diagram:
Measurement control commands are of the following type (see also Firmware Applica-
tions):
SCPI subsys-
tem
<Application>,
e.g.
Measurement instance Context
INITiate
ABORt
STOP
:WIMax |
:GPRF
:MEASurement<i> :POWer
:EPSensor
:MEValuation
...
(depending on <Application>)
Control of the Instrument